Metrohm tiamo 1.1 Manual - Manual (Page 438)

410 Method
Time interval measuring point
0.1 ... [ 2.0 ] ... 999999 s (Titrando)
0.08 ... [ 2.00 ] ... 16200 s (Titrino)
Time interval for entering a measuring point in the list of measuring points.
Stop conditions
Screenshot and parameters: see SET pH - Stop conditions
Conditioning
Screenshot and parameters: see SET pH - Conditioning
Additional evaluations
Screenshot and parameters: see SET U - Additional evaluations
Additional measured values
Screenshot and parameters: see DET pH - Additional measured values
KFT Upol
Command for Karl Fischer Titrations with amperometric measurement (select-
able polarization voltage).
Devices
This command can be executed with the following devices which have the KFT
mode:
Titrino: 720, 736, 751, 758, 784, 795, 799
Titrando: 835, 836, 841
Appearance
The command has the following appearance:
without conditioning with conditioning
Parameters
The parameters for the command KFT Upol are configured in the following 8 tabs:
•
General/Hardware
Parameters for devices, dosing devices, sensors and stirrers.
• Start conditions
Parameters for the measurement of the initial measured value and for