Metrohm tiamo 1.1 Manual - Manual (Page 151)

Subwindow Run 123
Autorepeat determination
on, [ off ]
If this option is switched on then at the end of a determination the next de-
termination with the same method will be started automatically. In order to
stop the autorepeat the determination has to be stopped with
[Stop] .
Data import
Switches the import of external data on and off for the fields on the tab Single de-
termination .
Import from balance
on, [ off ]
If this option is switched on then external data from the selected balance
will be imported into the fields on the tab
Single determination . Data can be
imported into the fields ID1...ID4 , Sample size and Sample size unit .
Note
In order to be able to import sample identifications from the balance the data
export must be set accordingly on the balance (use names
ID1 , ID2 , ID3 , ID4 ).
Balance
Device name
Selection of the balance from which data is to be imported.
Always accept data
[ on ], off
If this option is selected then the data transmitted from the balance will be
imported into the tabs Single determination of all opened workplaces for
which this balance has been defined as the data source.
Accept data only for active window
on, [ off ]
If this option is selected then the data transmitted from the balance will only
be imported into the tab
Single determination of the active workplace.
Import from barcode reader
on, [ off ]
If this option is selected then external data from the selected barcode
reader will be imported in the fields on the tab
Single determination . The field
into which the data is to be imported is defined in the device properties of
the Barcode reader.
Barcode reader
Device name
Selection of the barcode reader from which data is to be imported.