Metrohm tiamo 1.1 Manual - Manual (Page 382)

354 Method
Switch on/off automatically
[ on ], off only 751, 785, 798, 799)
If this option is enabled, the stirrer will be switched on automatically at the
start of the command and will be switched off automatically at the end of
the command.
Start conditions
Screenshot and parameters: see DET U - Start conditions
Titration parameters
Screenshot and parameters: see DET pH - Titration parameters
Stop conditions
Screenshot and parameters: see DET U - Stop conditions
Potentiometric evaluation
Parameters for the potentiometric evaluation of the titration curve with automatic
equivalence point recognition. One of the following evaluation methods can be
chosen:
Command name
25 characters, [ DET Ipol # ]
Name of the command.
Evaluation without window
Parameters: see DET pH - Potentiometric evaluation
Evaluation with measured value window (Ipol)
Screenshot and parameters: see DET pH - Potentiometric evaluation
Evaluation with volume window (mL)
Screenshot and parameters: see DET pH - Potentiometric evaluation