Metrohm tiamo 1.1 Manual - Manual (Page 148)

120 Workplace
the set counter then the current statistical data will first be deleted and
the statistics counter reset to
0 .
6 - Main run
When processing the loaded method the following actions can be carried out:
• Process main track
After the start of the Main track the status changes to BUSY . The com-
mands of the main track and the other tracks that it calls up are proc-
essed in sequence. If the main track calls up tracks that are not free
then a pause will be made until these tracks can be started.
• Interrupt and continue run
A running determination can be interrupted at any time with [Hold] and
then continued with [Cont] . All the active tracks will be stopped and
continued together.
• Cancel sequence
A running series can be canceled at any time with [Stop] . An Exit track
may be carried out; the determination will be terminated.
• Cancel by error
If when a determination is being carried out an error occurs that
causes the cancellation of the determination then an Error track may
be carried out; the determination will be terminated.
• Process exit track
When the main track and all the other tracks that it has called up have
been completed then an Exit track may be carried out; the determina-
tion will be terminated. After the end of the Main track the status
changes to
READY .
7 - Post-conditioning (only for methods with conditioning)
In methods that contain commands with switched-on conditioning and in which
the option
Automatic conditioning is switched on in the START command then for all
these commands post-conditioning will be started automatically with the loaded
method immediately after the end of the track that contains the conditioning
command.
• Conditioning requirement not fulfilled
After the start of post-conditioning the status changes to COND BUSY .
In this status a new determination can be started with [Start] , even
though the conditioning requirement has not been fulfilled. Condition-
ing can also be canceled with
[Stop] or interrupted with [Hold] and
then continued with [Cont] . If an error occurs during conditioning then
neither the Error track nor the Exit track will be carried out.
• Conditioning requirement fulfilled
If the conditioning requirement has been fulfilled then the status
changes to
COND READY . In this status a new determination can be
started with [Start] . Conditioning can also be canceled with [Stop] or
interrupted with [Hold] and then continued with [Cont] . The condition-
ing requirement will continue to be monitored continuously until the
determination has been started.