Metrohm tiamo 1.1 Manual - Manual (Page 446)

418 Method
Drift correction
automatic, manual, [ off ]
If this parameter is set to automatic or manual the drift correction ( = Drift
value x Titration time) caused by blank consumption during titration is de-
ducted from the total consumption. With automatic the drift value at the start
of the titration applies with manual the value defined under Drift value is ap-
plied.
Drift value
[ 0 ] ... 99.9 µL/min
Drift value for drift correction. This parameter is only shown for Drift correc-
tion = manual .
Delay after 'Cond ok'
[ 0 ] ... 999 s
Waiting period until the start of the titration during which the conditioning
condition must be fulfilled.
Only start titration by a start command from a SEND command
on, [ off ]
If this option is set the titration is only started when the Event message Start
titration from a SEND command reaches this command.
Note
At the time of reception of the SEND command conditioning must already be
terminated (= Condok ) otherwise the command to start the titration will be ig-
nored.
Show measured value during conditioning
on, [ off ]
If this option is set additionally to the drift and time the measured value is
shown in the Live display.
Additional evaluations
The following additional method for evaluation of titration curves can be activated
and defined here:
Command name
25 characters, [ KFC # ]
Name of the command.
Fix end point evaluation
on, [ off ]
For a fixed measured value for the fix end point the associated values are
interpolated from the list of measuring points.