Metrohm tiamo 1.1 Manual - Manual (Page 277)

Subwindow Determination overview 249
the asterisks will disappear. Updating the statistics data always only takes
place with
[Recalculate] .
With this button all the individual results selected in the table for statistical
calculations can be switched on and off. If the result is switched off then an
asterisk ( * ) appears behind the result value in the table; if it is switched on
again then the asterisk will disappear. Updating the statistics data always
only takes place with
[Recalculate] .
Note
If the results of a determination are switched off then when this determination is
recalculated the statistics for these results will be switched off, i.e. no data for
the mean value and standard deviations will be shown. However, the determina-
tions remain statistically linked to each other so that the results can also be
switched on again.
Curve evaluation
Curves that can be evaluated manually can be shown here.
Note
The tab Curve evaluation is only shown when a single determination that contains
curves that can be evaluated has been selected.
Command name
Command name
Selection of the measuring command ( command name.index - command
type ) for which the curve is to be shown for reprocessing.
Opens the window Curve evaluation for manually reprocessing the curve
evaluation.