Metrohm tiamo 1.1 Manual - Manual (Page 152)

124 Workplace
Always accept data
[ on ], off
If this option is selected then the data transmitted from the barcode reader
will be imported into the tabs Single determination of all opened workplaces
for which this barcode reader has been defined as the data source.
Accept data only for active window
on, [ off ]
If this option is selected then the data transmitted from the barcode reader
will only be imported into the tab
Single determination of the active work-
place.
3.5.3 Determination series
Overview
On the tab Determination series in the subwindow Run parameters and sample
data for a determination series can be edited and run functions triggered. It in-
cludes the following tools and function:
• Operating tools
Buttons for starting, stopping, interrupting and continuing determina-
tions and series.
• Status display
Shows the current status of the workplace.
• Determination parameters
Entry of general parameters for the determinations.
•
Sample data
Entry of sample data for the next determinations.
•
Properties
Definition of the properties for the tab Determination series .
Operating tools
On the tab Determination series the following operating tools can be found:
Start series (short cut: Ctrl G)
Starts the first determination of a sample series. The button is present in the
status
READY (no determination has been started). If a start can be trig-
gered it is green, otherwise it is light gray. In methods with conditioning the
conditioning is started first, and then (status
COND READY ) the determination
starts automatically.