Metrohm tiamo 1.1 Manual - Manual (Page 465)

Commands 437
• Monitoring
Definition of measured value, dosing rate, and temperature monitor-
ing.
• Evaluations
Definition of methods for evaluation of the titrations curves.
• Additional measured values
Definition of additional measured values of other measuring com-
mands which are saved as additional column in the list of measuring
points.
General/Hardware
The general parameters for the control device, the dosing device, sensor and the
stirrer are defined on this tab.
Command name
25 characters, [ STAT U # ]
Name of the command.
Device
Device name
Device name, [ not defined ]
Selection of the device from device table. Only those devices being able to
execute the command are selectable. Additionally,
not defined can be se-
lected. In this case, the device name must be assigned by the user at the
start of the method.