Metrohm tiamo 1.1 Manual - Manual (Page 605)

Commands 577
REQUEST - sample data request
Message
Displaying the message defined in the command REQUEST .
Sample position
[ 1 ] ... 999
Position of the sample on the sample rack. This number can be used for
moving to a sample position with the command
MOVE with the Target posi-
tion = Sample position .
ID1 ... ID8
-1.0E-99 ... 1.0E+99 (for Type = Number )
100 characters (for Type = Text )
'YYYY-MM-DD' or 'YYYY-MM-DD hh:mm:ss' (for Type = Date/Time )
Sample identifications.
Note
In case the sample identifications are invalid at the start of the method because
they are entered with the
REQUEST command during the run, the option Check at
start in the START command must be switched off for these method variables.
Sample size
[ 1 ], 10 numbers
Sample size.
Sample size unit
[ g ], mg, µg, mL,µL, pieces
Unit of the sample size (text only).
Note
Sample data can be read in from a balance or a barcode reader. The data
import must therefore be switched on in the window Run (Single determination
or Determination series) and the corresponding devices must be defined. The
dialog window
Sample data request will be closed automatically after the data
have been received from these devices.
In case the option Comments on modification of sample data (live) is activated in
the Security settings, the dialog window Modification comment sample data (see
Subwindow Run - Single determination - Modification comment sample data) is
displayed after entering the sample data. A
Reason and a Comment must be en-
tered for the modification.