Metrohm tiamo 1.1 Manual - Manual (Page 488)

460 Method
[ automatic ]
If a temperature sensor is connected, the temperature will be measured
continuously. Otherwise the temperature manually entered under Tempera-
ture (see Measuring parameters) will be used.
off
The temperature will not be measured. The temperature manually entered
under
Temperature (see Measuring parameters) will be used.
Stirrer
Stirrer
[ 1 ] ... 4, off (Titrando only)
Selection of the stirrer. off means that no stirrer will be used.
Stirring rate
-15 ... [ 8 ] ... 15 (Titrando only)
Setting the stirrer speed. The direction in which stirring takes place changes
as the sign in front of the stirrer speed changes.
Switch off automatically
[ on ], off (Titrando only)
The stirrer is automatically switched off at the end of the command if this
option is activated.
Measuring parameters
The measuring parameters are defined on this tab.
Command name
25 characters, [ MEAS U # ]
Name of the command.
Measurement
The two measuring modes Measurement with drift control or Meas-
urement without drift control are selectable.