Metrohm tiamo 1.1 Manual - Manual (Page 718)

690 Configuration
Opens the dialog window Rack data (see Configuration - Subwindow Rack
data - Rack properties) or Rackdata (774) in which the data of the attached
rack is shown and can be edited.
Initializes the attached rack. This resets the rack, lift and swing head, reads
off the rack code and transfers the corresponding rack data to the Sample
Processor.
Dosing device
Shows the number and type of dosing devices connected to the 730 Sample
Changer or 774 Oven Sample Processor. A maximum of 12 type
685 Dosimat
or 700 Dosino dosing devices can be connected.
Note
Connecting up the dosing devices is described in the Instructions for Use for the
730 Sample Changer and 774 Oven Sample Processor. If no dosing device is
connected then the card will remain empty.
RS 232
COM Port
COM1, COM2, ..., [ first free COM port ]
Selection of the serial interface on the PC to which the device is connected.
Baud rate
1200, 2400, 4800, [ 9600 ]
Transmission speed. Additionally, this baud rate must be set on the device
itself.