Metrohm tiamo 1.1 Manual - Manual (Page 276)

248 Database
all the earlier method versions will be deleted and a new version will be
generated with the number
1 .
Statistics
Individual results for the statistical calculation can subsequently be switched on
and off here.
Note
The tab Statistics will only be shown when the last determination (and only this
one) is selected from a set of determinations which, because of the statistics de-
fined in the method, belong together.
Results with statistics
Result name
Result name
Selection of the statistically evaluated result by using the result name for
which the individual results of all determinations are shown.
Table of individual results
For the result selected above the following data for the individual determi-
nation is shown:
Determination start
Shows the date and time at which the determination was started.
Version
Shows the version number of the determination.
Sample size
Shows the sample size.
Result value
Shows the result value. The statistical data (mean value, standard devia-
tions, etc.) for the selected determination are listed in the subwindow
Result
view .
With this button all the individual results for the selected determination can
be switched on and off for the statistical calculations. If the determination is
switched off then an asterisk ( * ) appears behind all the result values in the
table and the line is shown as inactive (gray); if it is switched on again then