Metrohm tiamo 1.1 Manual - Manual (Page 715)

Subwindow Devices 687
730 Sample Changer
The parameters for the 730 Sample Changer are set on the following tabs:
• General
General device information such as device name, device type, serial
number, etc.
• Towers
Properties of Tower 1 and Tower 2 (if present).
• Rack
Information about the attached rack.
• Dosing devices
Properties of the connection and the dosing devices connected to it.
•
RS232
Selection of the serial interface to which the device is connected.
• GLP
Information about GLP test and GLP monitoring.
General
Device name
50 characters, [ device type number_# ]
Name of device (can be freely defined by user).
Device type
Shows the type of device.
Program version
Shows the program version of the device.
Opens the dialog window Load new program version . This button is only ac-
tive when the device has an old program version that is not supported by
tiamo which can be updated by tiamo itself.
Device serial number
Shows the serial number of the device.
Set to work
Shows the date on which the device was automatically added to the device
table.
Working hours
Shows the number of operating hours (only for 778, 789, 814, 815, and 855
devices).