Metrohm tiamo 1.1 Manual - Manual (Page 56)

28 General program functions
Identifier Description Commands
.SPO Current external position (entry at end of command);
0 means invalid position
SWING
.STE Start temperature (temperature after processing the
start conditions) in °C DET, MET, SET, KFT,
KFC, STAT
.STY Stop type with which the command has been stopped:
1 = normal;0 = manual or after error DET, MET, SET, KFT,
STAT, MEAS, CAL
MEAS, STDADD, DOS
.SVA Start volume absolute (volume added in accordance
with the start condition "Start volume") in mL DET, MET, SET, KFT,
STAT
.SVM Start volume measured value (volume added in accor-
dance with the start condition "Start measured value")
in mL
DET, MET
.SVS Start volume measured value (volume added in accor-
dance with the start condition "Start slope") in mL DET, MET
.SVT Start volume total (volume added in accordance with
all three start conditions) in mL DET, MET, SET, KFT,
STAT
.TITER Titer value for the solution used for the command DET, MET, SET, KFT,
STAT, STDADD dos,
STDADD auto, ADD,
DOS, LQH
.TOU Timeout status: 1 = max. delay period elapsed;
0 = max. delay period not elapsed RECEIVE, TRANSFER;
SCAN
.VAR Variance of the calculated standard addition result in
selected unit STDADD
.VOL Added volume STDADD, ADD, DOS,
LQH