Metrohm tiamo 1.1 Manual - Manual (Page 550)

522 Method
Parameters
The parameters for the command DOS U are configured in the following 5 tabs:
• General/Hardware
Parameters for devices, dosing devices, sensors and stirrers.
• Dosing parameters
Parameters for the dosing settings.
•
Stop conditions
Definition of conditions which cause the stop of the dosing.
•
Monitoring
Definition of measured value and temperature monitoring.
• Additional measured values
Definition of additional measured values of other measuring com-
mands which are saved as additional column in the list of measuring
points.
General/Hardware
The general parameters for the control device, the dosing device and the stirrer
are defined on this tab.
Command name
25 characters, [ DOS U # ]
Name of the command.