Metrohm tiamo 1.1 Manual - Manual (Page 486)

458 Method
Additional measured values
Screenshot and parameters: see DET pH - Additional measured values
MEAS U
Command for potentiometric voltage measurements.
Devices
This command can be executed with the following devices:
Titrino: 702, 716, 718, 719, 720, 721, 736, 751, 758, 785, 794, 798, 799
Titrando: 808, 809, 835, 836, 841
Appearance
The command has the following appearance:
Parameters
The parameters for the command MEAS U are configured on the following 4 tabs:
• General/Hardware
Parameters for device, sensor and stirrer.
• Measuring parameters
Parameters for the measurement.
•
Evaluations
Defining further methods for evaluating measurement curves.
• Additional measured values
Defining further measured values which can be saved as additional
columns in the list of measuring points.