Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 999)

Brocade 6910 Ethernet Access Switch Configuration Guide 949
53-1002581-01
Simple Network Management Protocol
42
Parameters
These parameters are displayed:
• IP Address – The Internet address of a remote device. The specified target host must already
have been configured using the Administration > SNMP (Configure Trap – Add) page.
NOTE
The notification log is stored locally. It is not sent to a remote device. This remote host
parameter is only required to complete mandatory fields in the SNMP Notification MIB.
• Filter Profile Name – Notification log profile name. (Range: 1-32 characters)
Interface
To create an SNMP notification log:
1. Click Administration, SNMP.
2. Select Configure Notify Filter from the Step list.
3. Select Add from the Action list.
4. Fill in the IP address of a configured trap manager and the filter profile name.
5. Click Apply
FIGURE 266 Creating SNMP Notification Logs
To show configured SNMP notification logs:
1. Click Administration, SNMP.
2. Select Configure Notify Filter from the Step list.
3. Select Show from the Action list.
FIGURE 267 Showing SNMP Notification Logs