Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 1134)

1084 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
Multicast VLAN Registration for IPv4
46
• Forwarding Priority – The CoS priority assigned to all multicast traffic forwarded into this
domain. (Range: 0-6, where 6 is the highest priority)
This parameter can be used to set a high priority for low-latency multicast traffic such as a
video-conference, or to set a low priority for normal multicast traffic not sensitive to latency.
• Upstream Source IP – The source IP address assigned to all MVR control packets sent
upstream on the specified domain. By default, all MVR reports sent upstream use a null source
IP address.
Interface
To configure settings for an MVR domain:
1. Click Multicast, MVR.
2. Select Configure Domain from the Step list.
3. Select a domain from the scroll-down list.
4. Enable MVR for the selected domain, select the MVR VLAN, set the forwarding priority to be
assigned to all ingress multicast traffic, and set the source IP address for all control packets
sent upstream as required.
5. Click Apply.
FIGURE 374 Configuring Domain Settings for MVR
Configuring MVR Group Address Profiles
Use the Multicast > MVR (Configure Profile and Associate Profile) pages to assign the multicast
group address for required services to one or more MVR domains.
CLI References
• “MVR for IPv4” on page 475
Command Usage
• Use the Configure Profile page to statically configure all multicast group addresses that will join
the MVR VLAN. Any multicast data associated with an MVR group is sent from all source ports
to all receiver ports that have registered to receive data from that multicast group.