Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 145)

Brocade 6910 Ethernet Access Switch Configuration Guide 95
53-1002581-01
Time
5
Current Server: 137.92.140.80
Console#
Related Commands
sntp server (95)
sntp poll (95)
show sntp (96)
sntp poll
This command sets the interval between sending time requests when the switch is set to SNTP
client mode. Use the no form to restore to the default.
Syntax
sntp poll seconds
no sntp poll
seconds - Interval between time requests. (Range: 16-16384 seconds)
Default Setting
16 seconds
Command Mode
Global Configuration
Example
Console(config)#sntp poll 60
Console#
Related Commands
sntp client (94)
sntp server
This command sets the IP address of the servers to which SNTP time requests are issued. Use the
this command with no arguments to clear all time servers from the current list. Use the no form to
clear all time servers from the current list, or to clear a specific server.
Syntax
sntp server [ip1 [ip2 [ip3]]]
no sntp server [ip1 [ip2 [ip3]]]
ip - IP address of an time server (NTP or SNTP). (Range: 1 - 3 addresses)
Default Setting
None
Command Mode
Global Configuration