Spanning-tree cost, Table 77, Table 78 – Brocade Communications Systems Brocate Ethernet Access Switch 6910 User Manual
Page 396
346
Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
Spanning Tree Commands
18
•
Before enabling BPDU Guard, the interface must be configured as an edge port with the
command. Also note that if the edge port attribute is disabled on an
interface, BPDU Guard will also be disabled on that interface.
Example
Console(config)#interface ethernet 1/5
Console(config-if)#spanning-tree edge-port
Console(config-if)#spanning-tree bpdu-guard
Console(config-if)#
Related Commands
spanning-tree spanning-disabled (354)
spanning-tree cost
This command configures the spanning tree path cost for the specified interface. Use the no form
to restore the default auto-configuration mode.
Syntax
spanning-tree cost cost
no spanning-tree cost
cost - The path cost for the port. (Range: 0 for auto-configuration, 1-65535 for short path
cost method
7
, 1-200,000,000 for long path cost method)
Default Setting
By default, the system automatically detects the speed and duplex mode used on each port, and
configures the path cost according to the values shown below. Path cost “0” is used to indicate
auto-configuration mode. When the short path cost method is selected and the default path cost
recommended by the IEEE 8021w standard exceeds 65,535, the default is set to 65,535.
TABLE 77
Recommended STA Path Cost Range
Port Type
Short Path Cost
(IEEE 802.1D-1998)
Long Path Cost
(802.1D-2004)
Ethernet
50-600
200,000-20,000,000
Fast Ethernet
10-60
20,000-2,000,000
Gigabit Ethernet
3-10
2,000-200,000
7. Use the
to set the path cost method.
TABLE 78
Default STA Path Costs
Port Type
Short Path Cost
(IEEE 802.1D-1998)
Long Path Cost
(802.1D-2004)
Ethernet 65,535
1,000,000
Fast Ethernet
65,535
100,000
Gigabit Ethernet
10,000
10,000