Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 584)

534 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
CFM Commands
25
• If a MEP has been configured on an interface with the ethernet cfm mep command, it must
first be deleted before CFM can be disabled on that interface.
• When CFM is disabled, hardware resources previously used for CFM processing on that
interface are released, and all CFM frames entering that interface are forwarded as normal
data traffic.
Example
This example enables CFM on port 1.
Console(config)#interface ethernet 1/1
Console(config-if)#ethernet cfm port-enable
Console(config-if)#
clear ethernet cfm ais mpid
This command clears AIS defect information for the specified MEP.
Syntax
clear ethernet cfm ais mpid mpid md domain-name ma ma-name
mpid – Maintenance end point identifier. (Range: 1-8191)
domain-name – Domain name. (Range: 1-43 alphanumeric characters)
ma-name – Maintenance association name. (Range: 1-43 alphanumeric characters,
maximum length is 44 minus the length of the domain name)
Default Setting
None
Command Mode
Privileged Exec
Command Usage
This command can be used to clear AIS defect entries if a MEP does not exit the AIS state when all
errors are resolved.
Example
This example clears AIS defect entries on port 1.
Console#clear ethernet cfm ais mpid 1 md voip ma rd
Console(config)#