Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 728)

678 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
Port Configuration
33
Interface
To configure port connection parameters:
1. Click Interface, Port, General.
2. Select Configure by Port Range from the Action List.
3. Enter to range of ports to which your configuration changes apply.
4. Modify the required interface settings.
5. Click Apply.
FIGURE 31 Configuring Connections by Port Range
Displaying Connection Status
Use the Interface > Port > General (Show Information) page to display the current connection
status, including link state, speed/duplex mode, flow control, and auto-negotiation.
CLI References
• “show interfaces status” on page 281
Parameters
These parameters are displayed:
• Port – Port identifier.
• Type – Indicates the port type. (100Base-TX, 100Base SFP, 1000Base-T, 1000Base SFP)
• Name – Interface label.
• Admin – Shows if the port is enabled or disabled.
• Oper Status – Indicates if the link is Up or Down.
• Media Type – Media type used for combination ports.
• Autonegotiation – Shows if auto-negotiation is enabled or disabled.
• Oper Speed Duplex – Shows the current speed and duplex mode.
• Oper Flow Control – Shows the flow control type used.