Configuring a standard ipv6 acl, Figure 203 confi – Brocade Communications Systems Brocate Ethernet Access Switch 6910 User Manual
Page 915
Brocade 6910 Ethernet Access Switch Configuration Guide
865
53-1002581-01
Access Control Lists
41
Interface
To add rules to an Extended IPv4 ACL:
1. Click Security, ACL.
2. Select Configure ACL from the Step list.
3. Select Add Rule from the Action list.
4. Select IP Extended from the Type list.
5. Select the name of an ACL from the Name list.
6. Specify the action (i.e., Permit or Deny).
7. Select the address type (Any, Host, or IP).
8. If you select “Host,” enter a specific address. If you select “IP,” enter a subnet address and the
mask for an address range.
9. Set any other required criteria, such as service type, protocol type, or control code.
10. Click Apply.
FIGURE 203
Configuring an Extended IPv4 ACL
Configuring a Standard IPv6 ACL
Use the Security > ACL (Configure ACL - Add Rule - IPv6 Standard) page to configure a Standard
IPv6ACL.
CLI References
•
“permit, deny (Standard IPv6 ACL)”
•
•