Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 131)

Brocade 6910 Ethernet Access Switch Configuration Guide 81
53-1002581-01
Line
5
Example
To set the silent time to 60 seconds, enter this command:
Console(config-line)#silent-time 60
Console(config-line)#
Related Commands
password-thresh (80)
speed
This command sets the terminal line’s baud rate. This command sets both the transmit (to
terminal) and receive (from terminal) speeds. Use the no form to restore the default setting.
Syntax
speed bps
no speed
bps - Baud rate in bits per second.
(Options: 9600, 19200, 38400, 57600, 115200 bps)
Default Setting
9600 bps
Command Mode
Line Configuration
Command Usage
Set the speed to match the baud rate of the device connected to the serial port. Some baud rates
available on devices connected to the port might not be supported. The system indicates if the
speed you selected is not supported.
Example
To specify 57600 bps, enter this command:
Console(config-line)#speed 57600
Console(config-line)#
stopbits
This command sets the number of the stop bits transmitted per byte. Use the no form to restore the
default setting.
Syntax
stopbits {1 | 2}
no stopbits
1 - One stop bit
2 - Two stop bits