Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 451)

Brocade 6910 Ethernet Access Switch Configuration Guide 401
53-1002581-01
Configuring Port-based Traffic Segmentation
20
Example
This example enables traffic segmentation globally on the switch.
Console(config)#traffic-segmentation
Console(config)#
traffic-segmentation session
This command creates a traffic-segmentation client session. Use the no form to remove a client
session.
Syntax
[no] pvlan session session-id
session-id – Traffic segmentation session. (Range: 1-4)
Default Setting
None
Command Mode
Global Configuration
Command Usage
• Use this command to create a new traffic-segmentation client session.
• Using the no form of this command will remove any assigned uplink or downlink ports,
restoring these interfaces to normal operating mode.
Example
Console(config)#traffic-segmentation session 1
Console(config)#
traffic-segmentation uplink/downlink
This command configures the uplink and down-link ports for a segmented group of ports. Use the
no form to remove a port from the segmented group.
Syntax
[no] traffic-segmentation [session session-id] {uplink interface-list [downlink interface-list] |
downlink interface-list}
session-id – Traffic segmentation session. (Range: 1-4)
uplink – Specifies an uplink interface.
downlink – Specifies a downlink interface.
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12)
port-channel channel-id (Range: 1-12)