Ethernet cfm port-enable – Brocade Communications Systems Brocate Ethernet Access Switch 6910 User Manual
Page 583
Brocade 6910 Ethernet Access Switch Configuration Guide
533
53-1002581-01
CFM Commands
25
ma-name – Maintenance association name. (Range: 1-43 alphanumeric characters,
maximum length is 44 minus the length of the domain name)
up – Indicates that the MEP faces inward toward the switch cross-connect matrix, and
transmits CFM messages towards, and receives them from, the direction of the internal
bridge relay mechanism. If the up keyword is not included in this command, then the MEP
is facing away from the switch, and transmits CFM messages towards, and receives them
from, the direction of the physical medium.
Default Setting
No MEPs are configured.
The MEP faces outward (down).
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
•
CFM elements must be configured in the following order: (1) maintenance domain at the same
level as the MEP to be configured (using the
command), (2) maintenance
association within the domain (using the
command), and (3) finally the MEP
using this command.
•
An interface may belong to more than one domain. This command can be used to configure an
interface as a MEP for different MAs in different domains.
•
To change the MEP’s MA or the direction it faces, first delete the MEP, and then create a new
one.
Example
This example sets port 1 as a DSAP for the specified maintenance association.
Console(config)#interface ethernet 1/1
Console(config-if)#ethernet cfm mep mpid 1 md voip ma rd
Console(config-if)#
ethernet cfm port-enable
This command enables CFM processing on an interface. Use the no form to disable CFM
processing on an interface.
Syntax
[no] ethernet cfm port-enable
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
•
An interface must be enabled before a MEP can be created with the
command.