Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 585)

Brocade 6910 Ethernet Access Switch Configuration Guide 535
53-1002581-01
CFM Commands
25
show ethernet cfm configuration
This command displays CFM configuration settings, including global settings, SNMP traps, and
interface settings.
Syntax
show ethernet cfm configuration {global | traps | interface interface}
global – Displays global settings including CFM global status, cross-check start delay, and
link trace parameters.
traps – Displays the status of all continuity check and cross-check traps.
interface – Displays CFM status for the specified interface.
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12)
port-channel channel-id (Range: 1-12)
Default Setting
None
Command Mode
Privileged Exec
Example
This example shows the global settings for CFM.
Console#show ethernet cfm configuration global
CFM Global Status : Enabled
Crosscheck Start Delay : 10 seconds
Linktrace Cache Status : Enabled
Linktrace Cache Hold Time : 100 minutes
Linktrace Cache Size : 100 entries
Console#
This example shows the configuration status for continuity check and cross-check traps.
Console#show ethernet cfm configuration traps
CC MEP Up Trap : Disabled
CC MEP Down Trap : Disabled
CC Configure Trap : Disabled
CC Loop Trap : Disabled
Cross Check MEP Unknown Trap : Disabled
Cross Check MEP Missing Trap : Disabled
Cross Check MA Up : Disabled
Console#