Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 613)

Brocade 6910 Ethernet Access Switch Configuration Guide 563
53-1002581-01
Chapter
26
OAM Commands
The switch provides OAM (Operation, Administration, and Maintenance) remote management tools
required to monitor and maintain the links to subscriber CPEs (Customer Premise Equipment). This
section describes functions including enabling OAM for selected ports, loop back testing, and
displaying device information.
efm oam
This command enables OAM functions on the specified port. Use the no form to disable this
function.
Syntax
[no] efm oam
TABLE 133 OAM Commands
Command Function Mode
efm oam Enables OAM services IC
efm oam critical-link-event Enables reporting of critical event or dying gasp IC
efm oam link-monitor frame Enables reporting of errored frame link events IC
efm oam link-monitor frame
threshold Sets the threshold for errored frame link events IC
efm oam link-monitor frame
window Sets the monitor period for errored frame link events IC
efm oam mode Sets the OAM operational mode to active or passive IC
clear efm oam counters Clears statistical counters for various OAMPDU message
types PE
efm oam remote-loopback Initiates or terminates remote loopback test PE
efm oam remote-loopback
test Performs remote loopback test, sending a specified number
of packets PE
show efm oam counters
interface Displays counters for various OAM PDU message types NE,PE
show efm oam event-log
interface Displays OAM event log NE,PE
show efm oam
remote-loopback interface Displays results of OAM remote loopback test NE,PE
show efm oam status
interface Displays OAM configuration settings and event counters NE,PE
show efm oam status
remote interface Displays information about attached OAM-enabled devices NE,PE