Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 460)

410 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
Configuring MAC Based VLANs
20
mac-vlan
This command configures MAC address-to-VLAN mapping. Use the no form to remove an
assignment.
Syntax
mac-vlan mac-address mac-address vlan vlan-id [priority priority]
no mac-vlan mac-address {mac-address | all}
mac-address – The source MAC address to be matched. Configured MAC addresses can
only be unicast addresses. The MAC address must be specified in the format
xx-xx-xx-xx-xx-xx or xxxxxxxxxxxx.
vlan-id – VLAN to which the matching source MAC address traffic is forwarded.
(Range: 1-4093)
priority – The priority assigned to untagged ingress traffic. (Range: 0-7, where 7 is the
highest priority)
Default Setting
None
Command Mode
Global Configuration
Command Usage
• The MAC-to-VLAN mapping applies to all ports on the switch.
• Source MAC addresses can be mapped to only one VLAN ID.
• Configured MAC addresses cannot be broadcast or multicast addresses.
• When MAC-based, IP subnet-based, and protocol-based VLANs are supported concurrently,
priority is applied in this sequence, and then port-based VLANs last.
Example
The following example assigns traffic from source MAC address 00-00-00-11-22-33 to VLAN 10.
Console(config)#mac-vlan mac-address 00-00-00-11-22-33 vlan 10
Console(config)#
show mac-vlan
This command displays MAC address-to-VLAN assignments.
Command Mode
Privileged Exec
TABLE 94 MAC Based VLAN Commands
Command Function Mode
mac-vlan Defines the IP Subnet VLANs GC
show mac-vlan Displays IP Subnet VLAN settings PE