Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 589)

Brocade 6910 Ethernet Access Switch Configuration Guide 539
53-1002581-01
CFM Commands
25
Example
This example shows detailed information about the local MEP on port 1.
Console#show ethernet cfm maintenance-points local detail mep interface ethernet
1/1
MEP Settings:
-------------
MPID : 1
MD Name : vopu
MA Name : r&d
MA Name Format : Character String
Level : 0
Direction : Up
Interface : Eth 1/ 1
CC Status : Enabled
MAC Address : 00-E0-0C-00-00-FD
Defect Condition : No Defect
Received RDI : False
AIS Status : Enabled
AIS Period : 1 seconds
AIS Transmit Level : Default
Suppress Alarm : Disabled
Suppressing Alarms : Disabled
Console#
TABLE 126 show ethernet cfm maintenance-points local detail mep - display
Field Description
MPID MEP identifier
MD Name The maintenance domain for this entry.
MA Name Maintenance association to which this remote MEP belongs
MA Name Format The format of the Maintenance Association name, including primary VID, character
string, unsigned Integer 16, or RFC 2865 VPN ID
Level Maintenance level of the local maintenance point
Direction The direction in which the MEP faces on the Bridge port (up or down).
Interface The port to which this MEP is attached.
CC Status Shows if the MEP will generate CCM messages.
MAC Address MAC address of the local maintenance point. (If a CCM for the specified remote MEP
has never been received or the local MEP record times out, the address will be set to
the initial value of all Fs.)
Defect Condition Shows the defect detected on the MEP.
Received RDI Receive status of remote defect indication (RDI) messages on the MEP.
AIS Status Shows if MEPs within the specified MA are enabled to send frames with AIS
information following detection of defect conditions.
AIS Period The interval at which AIS information is sent.
AIS Transmit Level The maintenance level at which AIS information will be sent for the specified MEP.