Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 174)

124 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
SNMP Commands
6
• Based on the default settings used in RFC 3014, a notification log can contain up to 256
entries, and the entry aging time is 1440 minutes. Information recorded in a notification log,
and the entry aging time can only be configured using SNMP from a network management
station.
• When a trap host is created with the snmp-server host command, a default notify filter will be
created as shown in the example under the show snmp notify-filter command.
Example
This example first creates an entry for a remote host, and then instructs the switch to record this
device as the remote host for the specified notification log.
Console(config)#snmp-server host 10.1.19.23 batman
Console(config)#snmp-server notify-filter A1 remote 10.1.19.23
Console#
show nlm oper-status
This command shows the operational status of configured notification logs.
Command Mode
Privileged Exec
Example
Console#show nlm oper-status
Filter Name: A1
Oper-Status: Operational
Console#
show snmp notify-filter
This command displays the configured notification logs.
Command Mode
Privileged Exec
Example
This example displays the configured notification logs and associated target hosts.
Console#show snmp notify-filter
Filter profile name IP address
---------------------------- ----------------
A1 10.1.19.23
Console#