Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 590)

540 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
CFM Commands
25
show ethernet cfm maintenance-points remote detail
This command displays detailed CFM information about a remote MEP in the continuity check
database.
Syntax
show ethernet cfm maintenance-points remote detail
{mac mac-address | mpid mpid}
[domain domain-name | level level-id | ma ma-name]
mac-address – MAC address of a remote maintenance point.
This address can be entered in either of the following formats: xx-xx-xx-xx-xx-xx or
xxxxxxxxxxxx
mpid – Maintenance end point identifier. (Range: 1-8191)
domain-name – Domain name. (Range: 1-43 alphanumeric characters)
level-id – Authorized maintenance level for this domain. (Range: 0-7)
ma-name – Maintenance association name. (Range: 1-43 alphanumeric characters,
maximum length is 44 minus the length of the domain name)
Default Setting
None
Command Mode
Privileged Exec
Command Usage
Use the mpid keyword with this command to display information about a specific maintenance
point, or use the mac keyword to display information about all maintenance points that have the
specified MAC address.
Example
This example shows detailed information about the remote MEP designated by MPID 2.
Console#show ethernet cfm maintenance-points remote detail mpid 2
MAC Address : 00-0D-54-FC-A2-73
Domain/Level : voip / 3
MA Name : rd
Primary VLAN : 1
MPID : 2
Incoming Port : Eth 1/ 2
CC Lifetime : 645 seconds
Age of Last CC Message : 2 seconds
Suppress Alarm Shows if the specified MEP is configured to suppress sending frames containing AIS
information following the detection of defect conditions.
Suppressing Alarms Shows if the specified MEP is currently suppressing sending frames containing AIS
information following the detection of defect conditions.
TABLE 126 show ethernet cfm maintenance-points local detail mep - display (Continued)
Field Description