Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 399)

Brocade 6910 Ethernet Access Switch Configuration Guide 349
53-1002581-01
Spanning Tree Commands
18
Command Usage
• If Port Loopback Detection is not enabled and a port receives it’s own BPDU, then the port will
drop the loopback BPDU according to IEEE Standard 802.1W-2001 9.3.4 (Note 1).
• Port Loopback Detection will not be active if Spanning Tree is disabled on the switch.
Example
Console(config)#interface ethernet 1/5
Console(config-if)#spanning-tree loopback-detection
spanning-tree loopback-detection action
This command configures the response for loopback detection to block user traffic or shut down
the interface. Use the no form to restore the default.
Syntax
spanning-tree loopback-detection action
{block | shutdown duration}
no spanning-tree loopback-detection action
block - Blocks user traffic.
shutdown - Shuts down the interface.
duration - The duration to shut down the interface.
(Range: 60-86400 seconds)
Default Setting
block
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• If an interface is shut down by this command, and the release mode is set to “auto” with the
spanning-tree loopback-detection release-mode command, the selected interface will be
automatically enabled when the shutdown interval has expired.
• If an interface is shut down by this command, and the release mode is set to “manual,” the
interface can be re-enabled using the
spanning-tree loopback-detection release command.
Example
Console(config)#interface ethernet 1/5
Console(config-if)#spanning-tree loopback-detection action shutdown 600