Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 617)

Brocade 6910 Ethernet Access Switch Configuration Guide 567
53-1002581-01
OAM Commands
26
Command Mode
Interface Configuration
Command Usage
When set to active mode, the selected interface will initiate the OAM discovery process. When in
passive mode, it can only respond to discovery messages.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#efm oam mode active
Console(config-if)#
clear efm oam counters
This command clears statistical counters for various OAMPDU message types.
Syntax
clear efm oam counters [interface-list]
interface-list - unit/port
unit - Unit identifier. (Range: 1)
port - Port number or list of ports. To enter a list, separate nonconsecutive port
identifiers with a comma and no spaces; use a hyphen to designate a range of ports.
(Range: 1-12)
Command Mode
Privileged Exec
Example
Console#clear efm oam counters
Console#
Related Commands
show efm oam counters interface (569)
efm oam remote-loopback
This command starts or stops OAM loopback test mode to the attached CPE.
Syntax
efm oam remote-loopback {start | stop} interface
start - Starts remote loopback test mode.
stop - Stops remote loopback test mode.
interface - unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12)