Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 988)

938 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
Simple Network Management Protocol
42
4. Enter a group name, assign a security model and level, and then select read, write, and notify
views.
5. Click Apply
FIGURE 254 Creating an SNMP Group
To show SNMP groups:
1. Click Administration, SNMP.
2. Select Configure Group from the Step list.
3. Select Show from the Action list.
FIGURE 255 Showing SNMP Groups
Setting Community Access Strings
Use the Administration > SNMP (Configure User - Add Community) page to configure up to five
community strings authorized for management access by clients using SNMP v1 and v2c. For
security reasons, you should consider removing the default strings.
CLI References
• “snmp-server community” on page 109