Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 227)

Brocade 6910 Ethernet Access Switch Configuration Guide 177
53-1002581-01
802.1X Port Authentication
9
dot1x system-auth-control
This command enables IEEE 802.1X port authentication globally on the switch. Use the no form to
restore the default.
Syntax
[no] dot1x system-auth-control
Default Setting
Disabled
Command Mode
Global Configuration
Example
Console(config)#dot1x system-auth-control
Console(config)#
dot1x intrusion-action
This command sets the port’s response to a failed authentication, either to block all traffic, or to
assign all traffic for the port to a guest VLAN. Use the no form to reset the default.
Syntax
dot1x intrusion-action {block-traffic | guest-vlan}
no dot1x intrusion-action
block-traffic - Blocks traffic on this port.
guest-vlan - Assigns the user to the Guest VLAN.
Default
block-traffic
Command Mode
Interface Configuration
Command Usage
For guest VLAN assignment to be successful, the VLAN must be configured and set as active (see
the
vlan database command) and assigned as the guest VLAN for the port (see the network-access
guest-vlan command).
Example
Console(config)#interface eth 1/2
Console(config-if)#dot1x intrusion-action guest-vlan
Console(config-if)#