Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 1140)

1090 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
Multicast VLAN Registration for IPv4
46
FIGURE 380 Assigning Static MVR Groups to a Port
To show the static MVR groups assigned to an interface:
1. Click Multicast, MVR.
2. Select Configure Static Group Member from the Step list.
3. Select Show from the Action list.
4. Select an MVR domain.
5. Select the port or trunk for which to display this information.
FIGURE 381 Showing the Static MVR Groups Assigned to a Port
Displaying MVR Receiver Groups
Use the Multicast > MVR (Show Member) page to show the multicast groups either statically or
dynamically assigned to the MVR receiver groups on each interface.
CLI References
• “show mvr members” on page 487
Parameters
These parameters are displayed:
• Domain ID – An independent multicast domain. (Range: 1-5)
• Group IP Address – Multicast groups assigned to the MVR VLAN.