Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 189)

Brocade 6910 Ethernet Access Switch Configuration Guide 139
53-1002581-01
Flow Sampling Commands
8
Example
This example sets the sample rate to 1 out of every 100 packets.
Console(config)#interface ethernet 1/9
Console(config-if)#sflow sample 100
Console(config-if)#
sflow source
This command enables sFlow on the source ports to be monitored. Use the no form to disable
sFlow on the specified ports.
Syntax
[no] sflow source
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet)
Example
This example enables flow control on ports 9 through 16.
Console(config)#interface ethernet 1/9
Console(config-if)#sflow source
Console(config-if)#
sflow timeout
This command configures the length of time samples are sent to the Collector before resetting all
sFlow port parameters. Use the no form to restore the default time out.
Syntax
sflow timeout seconds
no sflow timeout
seconds - The length of time the sFlow process continuously sends samples to the
Collector before resetting all sFlow port parameters. (Range: 0-10000000 seconds, where
0 indicates no time out)
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet)