Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 372)

322 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
Automatic Traffic Control Commands
16
snmp-server enable port-traps atc broadcast-control-apply
This command sends a trap when broadcast traffic exceeds the upper threshold for automatic
storm control and the apply timer expires. Use the no form to disable this trap.
Syntax
[no] snmp-server enable port-traps atc broadcast-control-apply
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet)
Example
Console(config)#interface ethernet 1/1
Console(config-if)#snmp-server enable port-traps atc broadcast-control-apply
Console(config-if)#
Related Commands
auto-traffic-control alarm-fire-threshold (319)
auto-traffic-control apply-timer (315)
snmp-server enable port-traps atc broadcast-control-release
This command sends a trap when broadcast traffic falls beneath the lower threshold after a storm
control response has been triggered and the release timer expires. Use the no form to disable this
trap.
Syntax
[no] snmp-server enable port-traps atc
broadcast-control-release
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet)
Example
Console(config)#interface ethernet 1/1
Console(config-if)#snmp-server enable port-traps atc broadcast-control-release
Console(config-if)#
Related Commands
auto-traffic-control alarm-clear-threshold (318)
auto-traffic-control action (317)
auto-traffic-control release-timer (316)