Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 566)

516 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
LLDP Commands
24
lldp dot3-tlv max-frame
This command configures an LLDP-enabled port to advertise its maximum frame size. Use the no
form to disable this feature.
Syntax
[no] lldp dot3-tlv max-frame
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
Refer to “Frame Size” on page 64 for information on configuring the maximum frame size for this
switch.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#lldp dot3-tlv max-frame
Console(config-if)#
lldp notification
This command enables the transmission of SNMP trap notifications about LLDP changes. Use the
no form to disable LLDP notifications.
Syntax
[no] lldp notification
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• This option sends out SNMP trap notifications to designated target stations at the interval
specified by the
lldp notification-interval command. Trap notifications include information
about state changes in the LLDP MIB (IEEE 802.1AB), or organization-specific LLDP-EXT-DOT1
and LLDP-EXT-DOT3 MIBs.
• SNMP trap destinations are defined using the snmp-server host command.
• Information about additional changes in LLDP neighbors that occur between SNMP
notifications is not transmitted. Only state changes that exist at the time of a trap notification
are included in the transmission. An SNMP agent should therefore periodically check the value
of lldpStatsRemTableLastChangeTime to detect any lldpRemTablesChange notification-events
missed due to throttling or transmission loss.