Figure 181 confi – Brocade Communications Systems Brocate Ethernet Access Switch 6910 User Manual
Page 888
838
Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
Web Authentication
41
Configuring Interface Settings for Web Authentication
Use the Security > Web Authentication (Configure Interface) page to enable web authentication on
a port, and display information for any connected hosts.
CLI References
•
Parameters
These parameters are displayed:
•
Port – Indicates the port being configured.
•
Status – Configures the web authentication status for the port.
•
Host IP Address – Indicates the IP address of each connected host.
•
Remaining Session Time – Indicates the remaining time until the current authorization session
for the host expires.
•
Apply – Enables web authentication if the Status box is checked.
•
Revert – Restores the previous configuration settings.
•
Re-authenticate – Ends all authenticated web sessions for selected host IP addresses in the
Authenticated Host List, and forces the users to re-authenticate.
Interface
To enable web authentication for a port:
1. Click Security, Web Authentication.
2. Select Configure Interface from the Step list.
3. Set the status box to enabled for any port that requires web authentication, and click Apply.
4. Mark the check box for any host addresses that need to be re-authenticated, and click
Re-authenticate.
FIGURE 181
Configuring Interface Settings for Web Authentication