Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 430)

380 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
Configuring VLAN Interfaces
20
Default Setting
By default only VLAN 1 exists and is active.
Command Mode
VLAN Database Configuration
Command Usage
• no vlan vlan-id deletes the VLAN.
• no vlan vlan-id name removes the VLAN name.
• no vlan vlan-id state returns the VLAN to the default state (i.e., active).
• You can configure up to 4093 VLANs on the switch.
NOTE
The switch allows 4093 user-manageable VLANs.
Example
The following example adds a VLAN, using VLAN ID 105 and name RD5. The VLAN is activated by
default.
Console(config)#vlan database
Console(config-vlan)#vlan 105 name RD5 media ethernet
Console(config-vlan)#
Related Commands
show vlan (387)
Configuring VLAN Interfaces
TABLE 85 Commands for Configuring VLAN Interfaces
Command Function Mode
interface vlan Enters interface configuration mode for a specified VLAN IC
switchport acceptable-frame-types Configures frame types to be accepted by an interface IC
switchport allowed vlan Configures the VLANs associated with an interface IC
switchport forbidden vlan Configures forbidden VLANs for an interface IC
switchport gvrp Enables GVRP for an interface IC
switchport ingress-filtering Enables ingress filtering on an interface IC
switchport mode Configures VLAN membership mode for an interface IC
switchport native vlan Configures the PVID (native VLAN) of an interface IC
switchport priority default Sets a port priority for incoming untagged frames IC
vlan-trunking Allows unknown VLANs to cross the switch IC