Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 558)

508 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
LLDP Commands
24
lldp refresh-interval
This command configures the periodic transmit interval for LLDP advertisements. Use the no form
to restore the default setting.
Syntax
lldp refresh-interval seconds
no lldp refresh-delay
seconds - Specifies the periodic interval at which LLDP advertisements are sent.
(Range: 5 - 32768 seconds)
Default Setting
30 seconds
Command Mode
Global Configuration
Example
Console(config)#lldp refresh-interval 60
Console(config)#
lldp reinit-delay
This command configures the delay before attempting to re-initialize after LLDP ports are disabled
or the link goes down. Use the no form to restore the default setting.
Syntax
lldp reinit-delay seconds
no lldp reinit-delay
seconds - Specifies the delay before attempting to re-initialize LLDP. (Range: 1 - 10
seconds)
Default Setting
2 seconds
Command Mode
Global Configuration
Command Usage
When LLDP is re-initialized on a port, all information in the remote systems LLDP MIB associated
with this port is deleted.
Example
Console(config)#lldp reinit-delay 10
Console(config)#