Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 142)

92 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
SMTP Alerts
5
Command Mode
Global Configuration
Command Usage
The specified level indicates an event threshold. All events at this level or higher will be sent to the
configured email recipients. (For example, using Level 7 will report all events from level 7 to level
0.)
Example
This example will send email alerts for system errors from level 3 through 0.
Console(config)#logging sendmail level 3
Console(config)#
logging sendmail destination- email
This command specifies the email recipients of alert messages. Use the no form to remove a
recipient.
Syntax
[no] logging sendmail destination-email email-address
email-address - The source email address used in alert messages. (Range: 1-41
characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
You can specify up to five recipients for alert messages. However, you must enter a separate
command to specify each recipient.
Example
Console(config)#logging sendmail destination-email [email protected]
Console(config)#
logging sendmail source-email
This command sets the email address used for the “From” field in alert messages. Use the no form
to restore the default value.
Syntax
logging sendmail source-email email-address
no logging sendmail source-email
email-address - The source email address used in alert messages. (Range: 1-41
characters)