Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 290)

240 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
IPv4 ACLs
11
access-list ip
This command adds an IP access list and enters configuration mode for standard or extended IPv4
ACLs. Use the no form to remove the specified ACL.
Syntax
[no] access-list ip {standard | extended} acl-name
standard – Specifies an ACL that filters packets based on the source IP address.
extended – Specifies an ACL that filters packets based on the source or destination IP
address, and other more specific criteria.
acl-name – Name of the ACL. (Maximum length: 32 characters, no spaces or other special
characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
• When you create a new ACL or enter configuration mode for an existing ACL, use the permit or
deny command to add new rules to the bottom of the list.
• To remove a rule, use the no permit or no deny command followed by the exact text of a
previously configured rule.
• An ACL can contain up to 64 rules.
Example
Console(config)#access-list ip standard david
Console(config-std-acl)#
Related Commands
permit, deny (241)
ip access-group (244)
show ip access-list (245)