Configuring by port range, Figure 30, Confi – Brocade Communications Systems Brocate Ethernet Access Switch 6910 User Manual
Page 727
Brocade 6910 Ethernet Access Switch Configuration Guide
677
53-1002581-01
Port Configuration
33
(Default: Autonegotiation enabled;
Advertised capabilities for
100Base-FX – 100full
1000BASE-T – 10half, 10full, 100half, 100full, 1000full;
1000Base-SX/LX/LH – 1000full)
•
Speed/Duplex – Allows you to manually set the port speed and duplex mode. (i.e., with
auto-negotiation disabled)
•
Flow Control – Allows automatic or manual selection of flow control.
Interface
To configure port connection parameters:
1. Click Interface, Port, General.
2. Select Configure by Port List from the Action List.
3. Modify the required interface settings.
4. Click Apply.
FIGURE 30
Configuring Connections by Port List
Configuring by Port Range
Use the Interface > Port > General (Configure by Port Range) page to enable/disable an interface,
set auto-negotiation and the interface capabilities to advertise, or manually fix the speed, duplex
mode, and flow control.
For more information on command usage and a description of the parameters, refer to
“Configuring by Port List” on page 675
.
CLI References
•