Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 1088)

1038 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
Address Resolution Protocol
43
Parameters
These parameters are displayed in the web interface:
• IP Address – IP address statically mapped to a physical MAC address. (Valid IP addresses
consist of four numbers, 0 to 255, separated by periods, and must match a known network
interface)
• MAC Address – MAC address statically mapped to the corresponding IP address. (Valid MAC
addresses are hexadecimal numbers in the format: xx-xx-xx-xx-xx-xx)
Interface
To map an IP address to the corresponding physical address in the ARP cache using the web
interface:
1. Click IP, ARP.
2. Select Configure Static Address from the Step List.
3. Select Add from the Action List.
4. Enter the IP address and the corresponding MAC address.
5. Click Apply.
FIGURE 332 Configuring Static ARP Entries
To display static entries in the ARP cache:
1. Click IP, ARP.
2. Select Configure Static Address from the Step List.
3. Select Show from the Action List.
FIGURE 333 Displaying Static ARP Entries