Displaying mvr6 receiver groups, Figure 394 s – Brocade Communications Systems Brocate Ethernet Access Switch 6910 User Manual
Page 1154
1104
Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
Multicast VLAN Registration for IPv6
46
4. Select an MVR6 domain.
5. Select the port or trunk for which to display this information.
FIGURE 394
Showing the Static MVR6 Groups Assigned to a Port
Displaying MVR6 Receiver Groups
Use the Multicast > MVR6 (Show Member) page to show the multicast groups either statically or
dynamically assigned to the MVR6 receiver groups on each interface.
CLI References
•
Parameters
These parameters are displayed:
•
Domain ID – An independent multicast domain. (Range: 1-5)
•
Group IPv6 Address – Multicast groups assigned to the MVR6 VLAN.
•
VLAN – The VLAN through which the service is received. Note that this may be different from
the MVR6 VLAN if the group address has been statically assigned.
•
Port – Indicates the source address of the multicast service, or displays an asterisk if the group
address has been statically assigned (these entries are marked as “Source”). Also shows the
interfaces with subscribers for multicast services provided through the MVR6 VLAN (these
entries are marked as “Receiver”).
•
Up Time – Time this service has been forwarded to attached clients.
•
Expire – Time before this entry expires if no membership report is received from currently
active or new clients.
•
Count – The number of multicast services currently being forwarded from the MVR6 VLAN.
Interface
To display the interfaces assigned to the MVR6 receiver groups:
1. Click Multicast, MVR6.
2. Select Show Member from the Step list.
3. Select an MVR6 domain.