Configuring acl mirroring, Figure 208 b – Brocade Communications Systems Brocate Ethernet Access Switch 6910 User Manual
Page 924
874
Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
Access Control Lists
41
FIGURE 208
Binding a Port to an ACL
Configuring ACL Mirroring
After configuring ACLs, use the Security > ACL > Configure Interface (Add Mirror) page to mirror
traffic matching an ACL from one or more source ports to a target port for real-time analysis. You
can then attach a logic analyzer or RMON probe to the target port and study the traffic crossing the
source VLAN(s) in a completely unobtrusive manner.
CLI References
•
“Local Port Mirroring Commands”
Command Usage
ACL-based mirroring is only used for ingress traffic. To mirror an ACL, follow these steps:
1. Create an ACL as described in the preceding sections.
2. Add one or more mirrored ports to ACL as described under
“Binding a Port to an Access Control
3. Use the Add Mirror page to specify the ACL and the destination port to which matching traffic
will be mirrored.
Parameters
These parameters are displayed:
•
Port – Port identifier.
•
ACL – ACL used for ingress packets.