Brocade Communications Systems Brocate Ethernet Access Switch 6910 - Manual (Page 231)

Brocade 6910 Ethernet Access Switch Configuration Guide 181
53-1002581-01
802.1X Port Authentication
9
Related Commands
dot1x timeout re-authperiod (181)
dot1x timeout quiet-period
This command sets the time that a switch port waits after the maximum request count (see
page 178 ) has been exceeded before attempting to acquire a new client. Use the no form to reset
the default.
Syntax
dot1x timeout quiet-period seconds
no dot1x timeout quiet-period
seconds - The number of seconds. (Range: 1-65535)
Default
60 seconds
Command Mode
Interface Configuration
Example
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout quiet-period 350
Console(config-if)#
dot1x timeout re-authperiod
This command sets the time period after which a connected client must be re-authenticated. Use
the no form of this command to reset the default.
Syntax
dot1x timeout re-authperiod seconds
no dot1x timeout re-authperiod
seconds - The number of seconds. (Range: 1-65535)
Default
3600 seconds
Command Mode
Interface Configuration
Example
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout re-authperiod 300
Console(config-if)#